Pulling a brand new part of model train track out of its box can be an extremely underwhelming experience. The particular black plastic cross connections and bright silver bed rails look next to practically nothing like their real life counterpart's rustic iron and worn wood. Fortunately, converting your track into a realistic representation is one of the very most rewarding parts of building a railroad model. Nevertheless, as with practically every aspect of modeling, a planning stage must be undertaken to tackle the basics before letting the trains roll.
After building your bench that will hold the train and sketching out your track plans that will make the best use of the space you have available, it's time to commence securing the trail to your layout. First, lay the track in the layout you have designed to ensure that it will fit. Get a train around on the few test runs most sold mounted ironing board to be sure the layout flows well. Feel free to make changes to your plan at this point - often, once you actually see your train in motion, you will find things that can make the whole picture flow better as you actually start to be able to easily visualize how all of your scenery will be approaching together in the near future.
When you are satisfied, it is time to lay down the roadbed. This is sold as cork or foam and can provide yet another way to lower train noise as well as raise the paths from the board to offer your track a more realistic look. Place the roadbed under the paths and mark where their exact positions. Then you can remove the tracks and glue the roadbed to your bench. Right after you've put a length of roadbed down, replace the tracks to ensure you are gluing the roadbed into the correct area.
Once the roadbed is in place, it's time for you to secure the track. Lay down the whole track to ensure everything is in its right place and test that all the rails are flush at their important joints by running a hand over the whole track layout. Some builders suggest soldering the track joints to provide a more strong track performance and power current, but deciding to do this will be based upon the permanence of your model and your technological proficiency in the soldering trade.
Modelers also argument the best way to secure the track, with some suggesting glue while others go with small nails or tacks put through the small holes in the cross ties. Both method will work, but it mainly depends upon your selected choice. Remember that working with glue can be a messy adventure, and also to clean up any spills promptly and often. Plus any glue left on the top of bed rails can cause electrical current problems or derailments in the foreseeable future.
And now we're finally to the portion of track mounting that enables your creative style glow. Most builders paint the rails of the tracks brown to give them a more realistic appearance, and several even go with a dark gray to spruce up their railroad connections. Be sure when piece of art rails to wipe off any excess paint on the tops of the rails. As with stuff, this will cause conductivity problems when you get started running your trains.
In addition to the last step is what really brings your model to life: adding the track ballast. Design railroad ballast comes in a variety of colors and styles, allowing you to choose the material that best fits your railroad and scenery. Sprinkle the ballast over your track, letting it fall in a natural form that mimics real rail ballast, being careful to obtain it between the rails and ties, not on them.
Voila! Your own track is almost distorted from the pieces you pulled out of the box, and looks almost identical to the actual paths that run from your town. There are other methods of laying track, such as Hand Laying, which requires modelers to lay down each cross tie and then add the side rails themselves, being sure to keep the correct gauge throughout the entirety of the track. But following the above steps will give you a realistic look for your track that will match the scenery you'll be preparing.